Elevator Forum

Are faults listed in owners manual on thumb drive silly

Can anybody pm me fault codes list to these units. Thx in advance

Thx gator, would of never thought of that

how do i see numbers come up rather than *

Does anyone know where to get an open ims tool Last edited by beaupeep; 04/02/15 01:55 AM.

Turns out there's a reset on the I/o board. Solved the problem. Thanks for the input guys

if I can see LEDs changing state on switch rack and criphna board, could it still be the car input/output board. How does this system work.

Where's the C10 PCB

Has anyone ever tried changing over a siemens to a s&s

Car ran after double reset, can dirt in in track cause door op to shutdown hard

My bad, had wire going to an unmarked input. Applied 24v and cleared problem.

Had similar problem years ago. Found an input that was labelled in drawing but no wire going to it. Jumped 24v to it and problem went away. Problem wo...