Elevator Forum

Originally Posted by Bobbybolognie I'm looking for the circuit these 4 door switches are used in so I might be able to attach an LED to show the custo...

So something is up with this unit. Take with Tom at PSI , said I definitely was using the correct cable, but I cannot communicate with the unit at all...

I got a '63 dc print half of the logic should be similar. Send a email and I will forward it.

Originally Posted by L1FT5.4ND.M0R3 Strange you’re comparing the two now, all of a sudden and out the blue. We are primarily EC Pixel, and I’m hoping ...

Determine you piston diameter Then determine your piston area by Pie Times Radius Squared. Piston Area = 3.1416*((Piston Dia/2)*(Piston Dia/2))Now tak...

Unspankable:It depends on who installed it. If it was a young mechanic following the instructions, you will need to lift the pltform to get the nuts o...

Don't take this the wrong way, but WTF is wrong with you, doing a field repair on a valve board? Call Bruace or Tanvir at Savaria and get the proper r...

Originally Posted by Tk #1 If any one comes across prints for old Dover hydro 2 slot would be great seems there wasn’t very many of them install Two ...

Lang Lay are a better rope for a basement traction as they are more flexible and handle the double or backward bend better. But either rope will work ...

Lav8rMEn depending on controller, you would just eliminate the up coil wiring if you use the KV1P, when the motor starts up it just pushed thru the va...

So the last three 1970s jobs I’ve requested prints from TKE for all came back as not available, got 1957 and a 1963 print from CJ Anderson in a matter...