Elevator Forum

Fault 713There is a Desciption to this Fault in another manual:The control deviation of the current control exceeds the value specified by supervisor ...

Fault 83No Supply 24VNo supply 24V connected to the Travel Control print (Variodyn E:PGO)This event will appear every time the mail switch JH deactiva...

Fault 11 refers to Fault 713 and that does not look good....713Current Difference Drive current doesn't matchdictation.Loss of gate firing signal. Che...

The "Sys: Message lost" normaly generates some errors in the event log? Have you checked the encoder parameters under Setup/Contract?Maybe try to defa...

solidstate<< Can I get a copy of the writeup to reprogram it?

That is a Fatal Error.Most Fatal Errors can be cleared by switching power on and off, or setting the controller on inspection.But in this case the Eep...

send me a pm...

coriice1<< If you are not an qualified lift engineer, you have no need for this. Please remember, that passenger and your own safety should come...

F1 = OvercurrentVacon frequency converter has measured too high current (>4xIn) in the motor output.*Sudden heavy oad increase *Check loading*Shot ...

Well, the manual to a SPEC90 has the same error code...CUR CONT >> 38 CUR CONT Current Control Abnormal, Fault./Alex