Elevator Forum

0289No 48Vdc F Power supply is dead for 5 seconds. This event is logged when only the 48VDC is dead and also when the controller is powered off.029048...

I assume you have tried the Learn Run more than one time? With the same result? The Gen2`s is normaly pretty stabile with the encoder feedback...Mlb b...

Get the cable from Bucher and download the iWIN software, you will get a much better overview on your laptop.

I have seen this before, units runs fine with the fault, but when you get "BadE2P" error at same time, all sorts of things can happen. I/O coding can ...

That is good news! Thanks for letting us know the result!F58 E2 checksum err (Fault Severity Level 1 = Log only)On power-up and after each EEPROM para...

if the machine is the same, it should not be a problem. But there is always a chance it will run in the wrong direction...Drop me a pm if you want the...

maybe the software in dsp was damaged under the repair? (static discharge). If you have another drive, try swapping the eproms...

F39 Bases DroppedThe DSP sends a bit to the host which indicates whether the IGBT bases are enebled or disabled, i.e. whether or not the transistors a...

it might be the parameter EFO-EX, that is set to only allow Phase 2 of the Fireman opration to end at the EFO floor (Where the EFS keyswitch is locate...

GECB/TCB(C) Status menu shows what? (M-1-1-1)

We use this one:

And you did enter all parameters from the documentation on site?I suspect that the new drive board has a newer software uploaded.If that is the case, ...

Did you use the eeprom from the old Drive?

Expect about 3 million cycles...

I have checked the manual, it does say LEM..?But what it stands for, I dont know. I suppose that it might be a PCB in the Drive (IGBT and current sens...