Notifications
Clear all
Topic starter
11/05/2015 3:27 pm
Hi,
I am a new member of the forum - hello all.
Have a problem with a Miconic VX-LR Hydraulic.
Lift out of order and main board display reads "EEPROM FATAL ERROR no grp conf data" after self test - tried power reset several times but still same problem.
Red fault LED illuminated all the time.
Any help much appreciated.
Would also appreciate manual if available.
11/05/2015 10:36 pm
That is a Fatal Error.
Most Fatal Errors can be cleared by switching power on and off, or setting the controller on inspection.
But in this case the Eeprom that holds all the parameters, is defective. Only way to solve it, is by ordering a new Eeprom from Schindler.
Most Fatal Errors can be cleared by switching power on and off, or setting the controller on inspection.
But in this case the Eeprom that holds all the parameters, is defective. Only way to solve it, is by ordering a new Eeprom from Schindler.