Elevator Forum

Notifications
Clear all

Tac 20/ dover

7 Posts
5 Users
0 Reactions
7,169 Views
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
Quote
(@sccjr)
Estimable Member
Joined: 17 years ago
Posts: 114
 
Not that I'm aware of, but if you suspect one of your sync sensors are bad you can jump the input signal from one side or the other. For example if you suspect the r/h sensor is bad jump the l/h signal to the r/h input. That will let the signals hit the processor at the exact same time even if the pistons are indeed out of sync.You can do this with the bottom or top switches.



   
ReplyQuote
(@beaupeep)
Honorable Member
Joined: 17 years ago
Posts: 316

   
ReplyQuote
(@sccjr)
Estimable Member
Joined: 17 years ago
Posts: 114

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
I know that the static sensors I/Os can be deleted, I have been told to do so by the factory, they said it doesn't need them on a 3 stop. I'm sure the dynamics could be too but I wouldn't recommend it, at some point you will end up bottoming out a stage or hitting a stop ring before you get to the floor. It's important the dynamics go off like 12" before the top slowdown and it is recommended to pull the springs and do a manual resync on every service.



   
ReplyQuote
(@whadafack)
Trusted Member
Joined: 17 years ago
Posts: 80

   
ReplyQuote
Share:
Scroll to Top