Elevator Forum

OTIS LRV COMPUTER C...
 
Notifications
Clear all

OTIS LRV COMPUTER CHIPS

8 Posts
5 Users
0 Reactions
7,468 Views
(@elevator-logic)
Trusted Member
Joined: 17 years ago
Posts: 37
Topic starter   [#28078]
Otis Removed a hydraulic unit from service years ago ( Removed Power Feed,Sealed Doors, Removed pipe ect). We were hired to put it back in service and have found that Otis Stole the LRV microprocessor from behind the COP. We have other LRV boards but we need the Computer Chips that are used on the microprocessor.. Is there any work around for this?



   
Quote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759

   
ReplyQuote
(@newmech)
Estimable Member
Joined: 17 years ago
Posts: 203

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
PM me a picture of the board, I should have software and chips for it. The first LRV used a 8749 Micro 40 pin with the software programmed to the chip. I have those too.

Last edited by Rolly; 10/31/19 02:57 AM.


   
ReplyQuote
(@elevator-logic)
Trusted Member
Joined: 17 years ago
Posts: 37

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
The board you have pic's of is an LRV5 Otis board with U10 & U11 chips. Are you sure this is the correct board for the job? There are many vintages and wiring diagrams of LRV Series. Need to have the correct processor board for the job U10 is a 27C512 chip and U11 is a 27C64. Sent you a PM.



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
If you do get the board, the HEEP Program can make chips (Hydraulic Elevator Eprom Programs). Makes the Generic and contract chip for boards.



   
ReplyQuote
(@huskervator)
Eminent Member
Joined: 17 years ago
Posts: 37
 
Just a question. In the State that I’m in, if you place an elevator back in service that has been decommissioned. The State will require it to comply with current code.



   
ReplyQuote
Share:
Scroll to Top