Notifications
Clear all
30/03/2026 11:53 pm
DSO means door safe to open. They should have a paper print to follow in the glide package
31/03/2026 5:50 am
Where do I get a signal from the glide to supply the dso that the gcs controller needs. Fso is front safe ooen correct? If so, will this supply the dso signal?
31/03/2026 8:49 am
Aside from going from 110vdc to 220vac, it should plug right in to the integration board. It is multidrop not discrete., it is a very straight forward swap.
Last edited by tayto; 03/31/26 12:50 AM.
01/04/2026 12:05 am
The glide has a dol wire. The gcs controller doesn't have a spot to land the wire. The at400 is sending a dol signal to the gcs controller that shows up in the parameters, a signal from the encoder through what wire though.
Last edited by Chris MEI; 03/31/26 04:25 PM.
01/04/2026 10:08 am
sounds like you got a discrete harness instead of multidrop
Last edited by tayto; 04/01/26 02:12 AM.
02/04/2026 10:08 am
DOL wire not required for multidrop, same as AT400.
Last edited by tayto; 04/02/26 02:13 AM.
Page 2 / 2
Prev