Elevator Forum

Gen2. Gov trip rese...
 
Notifications
Clear all

Gen2. Gov trip reset

25 Posts
10 Users
0 Reactions
25.5 K Views
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
Quote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776

   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@upanddown2321)
Trusted Member
Joined: 17 years ago
Posts: 96

   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
There’s no print. Just an owners manual that is garbage pretty much

Last edited by Jluff; 08/23/19 01:30 PM.


   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
If you don't have a print you do not belong working on that equipment. After watching the video of what happened in NYC I would stress this.

https://nypost.com/2019/08/22/video... levator-at-manhattan-promenade-building/



   
ReplyQuote
(@upanddown2321)
Trusted Member
Joined: 17 years ago
Posts: 96

   
ReplyQuote
(@workingclass)
Trusted Member
Joined: 17 years ago
Posts: 61
 
very much agreed. the time of poking around and randomly looking for terminal points is over, especially with gen2 and other fully solid state controllers. too much can go wrong and theres too much risk. just call for your adjuster if you are not familiar with the equipment at hand.



   
ReplyQuote
(@jluff)
Noble Member
Joined: 17 years ago
Posts: 776
Topic starter  
I’m not poking around. I have been in the business for 30 years . The prints were taking off job. As well as testing procedures that include the gov trip reset.



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
Ok then post a wiring diagram number and maybe you can get a set of prints. Asking for terminals to use is absurd without knowing wiring diagram number. After 30 years you should know that.



   
ReplyQuote
(@huskervator)
Eminent Member
Joined: 17 years ago
Posts: 37
 
ANSI code requires that testing procedures and wiring drawings are required to be accessible to the technician. Have the superintendent or sales contact the customer/owner.



   
ReplyQuote
(@bill-hempel)
New Member
Joined: 17 years ago
Posts: 2
 
A Gen 2 has a set reset button that is activated by the tool. You will find gov set and reset command on tool and when enabled you push the set reset button on controller



   
ReplyQuote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729
 
Bill Hempel, we all know that it can be done with a tool but you can energize the Gov Reset Solonoid WITHOUT a tool and reset the Gov.



   
ReplyQuote
Page 1 / 2
Share:
Scroll to Top