Elevator Forum

Yep, just run a hoistway setup. Don't forget to validate floors.

Merry Christmas!!

Welcome aboard.

1098 HDIF Failure - HDIF and HDIFM were in the same state.Usually N/O contact on your HDIF relay. Probably have spare N/O contact to use. Last edi...

UA

Go to device manager and see what Com Port your USB to serial is. Change your IMS config to that com port. I've had very little luck using the Prolifi...

PM sent...

I've got one of those... Southeastern, and if that is one foot in the grave mine has both. That looks pretty clean. Hate the valves.

Door WatchDog closing failure � DCL input did not activate in expected time interval. S Verify D21 and/or D22 adjustments Last edited by xxXBlazeX...

So what happens after you clear display C? Does it restart the count? Making it impossible to shutdown within 30 days after the clear? And if it shuts...

Glad you got it.

Thanks for the info. I've tried to see a pattern of any of the counts on Display C and D. I haven't found anything definite to know for sure what shut...

Probably would be best to start a new post since this is a new subject. But it might be your U15 chip (if I remember correctly). They do go bad, about...

Check your LUD circuit. Possibly relay not picking or welded N/C contact.