Elevator Forum

Originally Posted by sampler yes. it goes for learning trip although without sim and after trip if it can not read sim it behaves as you menioned. Gr...

Originally Posted by Alex75 The com settings for a SCIC Q3.1 board shoud be as below....Baud Rate 9600 Data Bit 8Parity NoneStop Bit 1Flow Control OFF...

Originally Posted by wiz GreetingsMy SCIC pcb Version 3.1. V3.1 is old. no wonder my RS232 to USB is not connecting. Anyone know if I can do a dip swi...

GreetingsMy SCIC pcb Version 3.1. V3.1 is old. no wonder my RS232 to USB is not connecting. Anyone know if I can do a dip switch to look at errors on ...

GreetingsIs the problem my RS232 cable?

Are you saying the SIM card might be faulty or not in place properly but lift did a shaft measurement?

Originally Posted by wiz GreetingsWe did a learning measurement trip on a schindler smart mrl 002 elevator using Dip Switch 8 on the main controller b...