Elevator Forum

Where can you buy the heating element and bubbler?

Yes I have tried re-teaching the nodes. Everything seems fine for a couple hours then the two cars shut down again with a 1688 fault.

I entered the DHNF command , all nodes read 1 with no faults. Would all of the HN’s need to be replaced? How can I update the firmware?

All pico fuses on all H/N’s are fine with no faults on any H/N board. Last edited by Wispaflex215; 04/27/21 02:42 PM.

I have used the Cadi on controllers without SIM cards.

I would replace the BH relay. It’s a mother [censored] to replace because it’s in the lower left hand corner of the controller with all the traveler w...

Have you looked at your brake circuit and relays to see if you relays were working and you had the correct voltages? Also check the rectifier in the b...

Sent

Yes I am

I could use the tool and the manual as well.