Elevator Forum

cw ver 20sel v27hnb v25and the new ver6 generic.I was wondering where the can termination is on the cwil? its on on the cpua then off going into the r...

Thanks dirt! Ill try that first

good find! ive changed drive boards because of the damn encoder.... had an encoder intermittently fail only at contract speed. all drive faults. the m...

replace the batteries

use the uit. ver2.24 is the newest software. go into the config menu and select linear. autonull relearn and you should be good to go

boards through thyssen have all door files preloaded and can be selected by going into the config section using the uit

reset and teach it a couple times.

what i usually do is put electrical tape on the inner opening of the transducer to get a perfect 3/4 from the edge of the vanes. Make sure the vanes a...

Probably on door disconnect. Need service tool to change parameter. Or a new door board

When you do a reinit i believe it loads the adjusted parameters from the cpu. Car should run. Maybe they changed something on the cpu and lost all the...

Should have a 6300py4 . Capacitor installed in the controller on p150 and g150. Make sure all the connector are on right and motor leads tight. Check ...

Raise power suppy voltage to 25.5 vdc and yeah u need to load software Last edited by Whadafack; 05/01/16 03:09 AM.