Elevator Forum

you will also need a special adapter from vertical express or a thyssen buddy that will allow you to hook up your laptop to the board and use hyper te...

thanks for the replies magic, i thought maybe the encoder was bad, so i did check M242, and ran the car up a floor, and back down to the exact spot i ...

it depends, we have replaced a few of the door boards on tac20 and tac32 the UDC boards come with a tag on it that says caution factory test software ...

Encoder is counting. Stops when ld comes on. Fault is 1ls distanceIs to large. Distance from ntb activation to bottom floor is to largeI tried setting...

can you move the door entrance 6" just a thought

good for 250 on off, i just turn it on, never turn it off just unplug had it for a couple of years now, probably only have 25 uses 250 will last a few...

eci west can do it had 2 of mine updated there 900 bucks

they sure are solid state, we were inquiring about one, they don't make that one any more says KONE, but will sell you a new upgraded one for 2600 buc...

well did not last long, client complaining again this time mechanic was next door and ran over to see and sure enough top floor hall call on, he made ...

does motion info screen 1 give any clue it gives you command velocity, max velocity for the run you are making, and reason for any velocity limit shou...

don't worry kiwi, i can't shoot straight anymore, can barely see the clock on the night stand. ha that dam dongle was a pain, whenever we needed it , ...

stopped by today, could not duplicate the problem, the job did have a group controller, one thing i did notice, while checking various parameters, was...