Elevator Forum

thanks guys. lucky you john jay, I'm only 1.5 years away, then i will also be doing the pointing. ha ha35 years is enough, time to get in that motor h...

thanks omms, that makes sense. so 100mm/s would be 19.69 fpm and 400mm/s would be 78.76fpm . still wondering why it faulted out at 400mm/s. trying to ...

i don't believe the parameter is for actual speed, the range was from 0-400at 100 it looked to run around 50fpm something like that did not take the t...

got it solved, access speed set at 400, cartop inspect speed set at 100. set access speed to 100 works great.

we decided to pass on the controller, sounded like a headache. We have been passing on all the new schindler and kone mrl cars.

horrible controller, should never have been installed. some buildings bit the bullet and modded after only a year or 2. there is no support for the un...

have not been back yet, maybe tomorrow, however i did some digging thru the parameters and have found that there is one parameter for cartop and contr...

i worked on this car a few months ago, had a problem with floor count, ended up having to relearn the hoistway. car has ran fine since, then the mecha...

either top or bottom access does not matter. up or down does not matter. overspeed parameters all set same as other cars. brake fine. tried it with do...

how much did you pay qa3ro? if you got it for free, it will expire soon.

sorry jkh RR2 controls open hi speed. look closely O2 closes and thru the already closed 03, this circuit jumps out rr4 for hi speed. notice the OHS n...

I have bought a few of the newest modelsOtis Test Tool Type:GAA21750AK3 USD190/pcthis is the model after the one with the dongle, It works on 211, 311...

146 in the manual says door zone failed on. 2000 code compliance. have you done anything with the landing system? overload displayed in the service ty...

did you try replacing the DZD relay? the little small relay on the i/o board