Elevator Forum

thanks guys, after some further inquiries, i was told that the positioning system does not rely on just the encoder only, from what I'm understanding,...

well did some playing with unit today, cleared all faults, gave it a long run and opened the door lock circuit, the car logged 5 errors, none of them ...

Ok its a 411mms. Also found pr inputs. In parrallel with lu and ld signalsGetting intermittent 2831 and 2832 errors. Both pointing to replacement of m...

it is a mod, not sure of the differnce between 411m and MMS, there were a few items this weekend relating to pr input errors. pr sensor error or somet...

there is a pattern, as the car will run down when the car is in the bottom 2/3 of the hoistway. also it will run up, but at a higher rate then the dow...

smitty, i found some info on the ds5 led coming on, besides power supply it mentions the upper and lower capacitor banks on the VL cards may cause thi...

so far no luck, still intermittent , but it happens in both directions , during accel, decel hi speed etc. sometimes runs for 2hours sometimes 15 min....

looks good rodney, can't download it as i have an iPhone, but looks like you know what your doing. would like to check out the parts request app, soun...

route organizer. have seen a few requests for people looking for program to track route. would be nice to have. last visit, notes, maps, job info, i h...

done a few of these, like whadafack said, need to load software through hyper terminal, then load the correct parameters. the new boards come with tag...

had same problem while installing new board,, had to reverse leads of motor in order to get a learn run, then all was well worth a shot

no ac ripple on power supply, stragnge thing is i have only see it happen in the up direction. ran it down as many times as up, an only faults in the ...

Just saw post name. Cp18. Is that the drive fault