Elevator Forum

have u replaced any boards, or software? make sure your software between the 2 cars are compatible. some of the newer software will not communicate wi...

It is p5-4 but on the DSS board in the drive I get 0 volts. I think this all has to do with my drive replacment. I have a OVFR02A-406, do i need to au...

Rope gripper is picked. I will check bp coil. Z picks bp tho, and z never comes in. I believe that’s a software signal I think from drive? Thanks ...

Check for any voltage on your input rack. You put ss(120vac ) to make call work. a blown diode can give you a back feed on your rack.

Got it running brake reg was bad. No good or bad lite on card.

Check the internal motor start contactor. If it is bad, pull wires out of contactor, Mount, and wire larger one outside of drive. This is a common pro...

sorry guys been bus . Going to work on this friday. thanks for the help. I will report back.

No just sup, IN. I will check switches again.

Are you a tech?

I agree

Have you replaced your reed switchs ? Sounds like you may have a flaky one. probably 61n. Also how are the guide shoes, and cab steadiers. When the do...