Elevator Forum

When you lose the PI programming how do you set it back to "B, 1, etc.."?

I would Replace power supply under CCBN board first. Could be dipping and losing voltage that feeds CCBN. Lower rise cars may not have a power supply....

Tayto thanks for the response. I have previously tried that setup and it did not work. Glad you were able to confirm I was on the right track. I think...

Any ideas ? Thanks for the help

GEN2 North AmericaI do not have that page in the schematic.

Finally got to this today. Had to set up a time with building bla bla bla. Anyways…I tried quite a few combinations to no prevail.I am including print...

Okay so I believe for an RS5 I’ll have 4 inputs and outputs.Dip switches give me an address of 60 -If I identify what input the switch is on, let’s sa...

GEN 2 GCSIT LOOKS LIKE EACH CAR HAS A SWITCH GOING TO AN RS-5 CARD6 dip switches1 and 2 are down the other four are up.

Not a problem Neville! Thanks for the help. Glad I am finally able to get my hands on some of this OTIS stuff.

Thanks for the quick response.I am pretty green to Otis equipment. Does each lift have an RSL card at the lobby panel?My lobby panel has a car to lobb...

Set 7-70 to whatever UI top floor

Check parameter 7-70 (HAS UPPER FLOOR)Check wiring correct in HAS boardIs the switch itself missing jumper?

Can someone with this manual send me a message. I have quite a few of these on route now and I'd love the help.