Elevator Forum

Update....we found the absolute encoder interface board burned. Replaced it and after a few minutes the new one burned up. We have another one and enc...

Got one ready for us to purchase. Thanks.

It is a Synergy and the pico fuse was blown. It blew again once power was turned on. How do you run it without the encoder to replace the encoder or r...

Thanks Vator and indirtwetrust. We only did TFR. After Vator's message and indirtwetrust's input, it is most likely the pico fuse. I ASSUMED we could ...

You should be able to get that info from Garaventa. If not pm me and I can get it to you

the door board is only going to do what the clc tells it to do. Will it work with the MDO and MCO?

We get ours from Vertical Express.

We got it. Put on another new board and it works fine. I don't know the old board number but the new board was 6300FX3.

Pm me or post ur email

Have you tried Quality Elevator? They can help you if you send them the picture. Texacone will also give you a hand.