Elevator Forum

AWESOME!! We got the TLS Keypad and was able to learn the shaft. It is up and running as of now. We have not turned it over yet, got to come back late...

My apologies for not posting this resolution in the first place. The problem turned out to be that the Generator we installed was wired for different ...

Oh yes. My bad for not posting. Thanks to all for the help. Generator was configured for wrong building voltage.

Yes we got all safe inputs up without an alignment. It will not run on inspect even with it set to 0. But it does appear ready to do an alignment. Wha...

Good news and then......We replaced the encoder,board and wiring from controller to the board. We got all our safe inputs in and are ready to do the b...

Thanks everybody. I spoke with EECO and they will build the sleeve.JKH95no21 yearsremoving wires and buttons, moving terminal and finals down There wi...

Can you do that with IMS or do you have to have the TLS Keypad?

I can send you what I have. Pm or post an email

Yes,C1 comes on before an attempt to run is made on inspection.

Have you tried eMr? They are in new Jersey

We have replaced encoder and board. We are not blowing the pico fuse. Still no Safe 3 input and have a fault code of C1 on the Drive. No fault codes o...

That is a different configuration. I have a set of prints for you. Pm me your email.

We were getting 24 volts to the board. Just got the info you sent me will double check that. The original board was the 6300xa1 as well as the new one...