Elevator Forum

Said it before, the magnets can lose juice...try putting a different magnet up there, verify you see NTST come active as you approach top floor, and y...

Exactly where I was going. Check calibration on your door tool. Check door times and unless you have poured lead into the doors you shouldn't be havin...

HD door operator or Linear?

Sounds like my superintendent....

I'm gonna gamble on the resistance load being inaccurate. Tons of jobs got turned over early with improper loads. You should have 60 Ohms on your CAN ...

Slip it, aerosol version is AWESOME.

I am trying to remember, think I used THLK for total hall lockout, then set mine up for FLOx. Been a super long time since I fired up a TAC20, I can l...

Hey, might be a good spot to start a different list:How many of your states outlaw using cellular for phones?I have heard California will not allow, a...

DRWDF I think is a Drive Watch Dog Fault. I also have not seen this fault before, but that's my guess.

Welding. Go get certified if you can afford it. Get your first aid/CPR CARD renewed at a local fire house. Brushing up on your basic math skills and y...

Rapid flashing means bad communication, SPI Loop. Bad L24 card, bad cables between the cards, are the usual culprits. Since this elevator has been in ...

Fire service resets have been notorious for being slow. Even on our TAC 32 units I teach customers to turn to reset, count to 5, then turn to off. Qui...

IDWT, did you guys install the LN cards in controllers? Our area, we always did them in the hoistway to TRY and help good signal strength. Mid hatch w...

Hal station boards are drop in, nothing special, L24 card I believe. LN card is in the hoistway. We used to put them mid hatch a lot, blown picos were...

Figured you would take it wrong. I have been in the trade for 16 years and I do check the other generic rankings thread, to see if I can be helpful in...