Elevator Forum

Check the back of the track for built up 'gunk'. If the door opens fully, then rolls back slightly, this will cause this error to generate.

I'll second the opinion stated above about the Gen2. It's a well thought out unit, easy to work on (inspection station in pit, well-lit overhead, etc....

Ratman is correct.

I know Schindler had a problem with the reliability of the safety brake mechanism, which contains a solenoid and also the monitoring contacts. Is it p...

This is not a cable issue, crimping problem, etc.This is a problem Schindler has been experiencing with all of their LON based hall call boards. Produ...

No-one thing is the same as their other units. The MTBC is supposedly atrocious.

I would be staying as far away from these as is humanly possible. Several have been rumored to be in possession of elevator companies in my area, and ...

I do remember when Schindler switched from the 321A to the 330A, they moved the power supply off of the board. You used to have the three phase power ...

I'm just going to guess, but it sounds like the power supply that feeds the 24 and 5 VDC is going bad. I've seen this before on many solid state units...

Are you talking about the amount of time the generator runs, the amount of time the transfer switch stays on the 'emergency power' side, or the amount...

I'd second Minnesota Elevator. When Schindler installed a corner post unit at Old Navy at the Mall of America, it was a non-standard platform, thus a ...

Originally Posted By: Broke_Sheave FujiChange software to disable diagnostics upon leaving the job.Kone.Changing a bit in LCE to turn off display.Schi...

What I have seen done in the past, and assisted in installation, is a camera that feeds it's signal back to the machine room via twisted pair or coax ...

Glad you found it!