Elevator Forum

I dont get status 40 and cant run on inspextion.the screens show BLCK ERR probably cause i disconnected VF and CAN otherwise will go back to rotating ...

I didn't get status 40 ,the 4 buttons are unresponsive.the version on CM11 board is 3.21 .How can download the BOD file back ?

An update,i disconnected CAN and VF and start commissioning mode ,i got this message now BLCK ERR and the 4 buttons are not responsive so still cant g...

Thanks guys ,i am going there tomorrow and try your suggestions.

You need to do couple learns ,I believe SPC and sp?Also make sure your bypass switches are not sticky ,turn them on off few times and try learn again ...

Hi Alex,do you know or have instruction on how to program the phones on 3300?

Hello friends. I have IMS software. IMS 32 bit ,16 bit I also have the latest version of IMS 2.7 now.Email me at [email protected] for details.

Check your power supply at bottom of the controller

Hello friends. I have IMS software. IMS 32 bit ,16 bit I also have the latest version of IMS 2.7 now.Email me at [email protected] for details.

Thanks