Elevator Forum

What drive?

When you did a shaft learn, did it throw any faults after the learn?If not then your shaft setup is correct.Have you checked rope slip through drive d...

Sounds like the MUL is online but the power hit locks it up until a full reset, I would have the building address their issue.

Lost communication to the COP node

Can you show me please?

Motor risk supervision counter (motor movement)Check your brakes

I’ve seen several times where world electronics boards specifically for DMCs do not work and they sent me another new one and it worked. Just putting ...

Sounds like you got it! Happy new year Dirt!

Did you go there today?

Nice one! I didn’t pay attention to the UI version! Last edited by MX4; 12/30/24 10:36 PM.

[img][/img]It’s worth a try either way

1-87 says it’s not used in North America but if you’re going behind somebody it’s worth it to check. Strange problem, at his point I would almost cond...

What’s your process of doing it?

Is parameter 1-87 a 0? If not I wonder if that is causing inference Also I wonder if the 7-51 has to be 255 (I know you are limited to 254) I was read...