Elevator Forum

101 RTRT_Fault Description:C o m m e n t s Extra Info:This error is only possible on elevators with a new safety circuit. European Global controller o...

If you have checked magnets, magnet distance, shaft setup, switch gap, switch then yes CCBN board could be failing Last edited by MX4; 05/30/24 05...

^ From 2014 manual, I would love to have a copy of latest also if it is out there

1926NP I/O mismatch with CPUA.• Reload controller software.1115The car failed to run because the door held.I don’t have the others

Nice one!

What was it?

Is this a way to ignore the bend cycles on belts?

Bowtiedrooster16, I 2nd that. Bad tach!

Command 102 I believe ignores encoder and brake feedback

Have you tried running open loop to check your brake switches?

0432 E_DRIVE_BRAKE_DISCONNECTOR_FAILUREThis section describes the 0400_0499_DRIVE error E_DRIVE_BRAKE_DISCONNECTOR_FAILURE.One or more brake power dis...

You can try to clear block on drive if any and dsp Have you cleared pf ram?

I’m no Otis guru, the fault is saying that fire service operation has mismatch values? Do you have gen2 manuals? If not I can send you them

M1221 M222M421 What does these say?

That KONE rail oil is the best in my opinion, expensive yes but that stuff sticks to the rail nicely.