Elevator Forum

Also according to inputs fsx is high I tried pulling wires for fsx cause prints show normally open also tried forcing input low in ims when I force it...

Didn’t try a call with clc the hall call is working fine the car will take the hall call. Not sure what happened on this job someone else went not eve...

Yeah the programming is correct. Checked that and checked all the lockouts none of the lock outs are on either

So issue I’m having cars been running but they lost the top floor car call. I have voltage at asx1-5 but call won’t latch and car won’t go to the top ...

So got there today car was down they said doors stopped working. Found a blown fuse in the door card and a 323 fault looks like we lost the armature c...

Thanks,I set the 5v had it at 5.15 I’m heading back to the job today to fine tune for the most part. I uploaded car 2 parameters to car one and change...

So we ended up replacing clc. I reprogrammed all parameters and did a hoistway scan fine. When I went to learn the pulse count the doors never cycle t...

Thanks I’ll give that a go come Monday

I'm late to the party but I would love the programming info on these we took over one after building sold and remodeled and phone goes to a monitoring...

Anyway someone can send me a copy of the manual as well. Thanks in advance. [email protected]