Elevator Forum

Thanks I’m heading to that job later in the week I will give it a look through before I head out there. Appreciate it!

So found some paperwork seems FIS/FIR control going in and out of fire service but I’m not sure what input controls said outputs. So any more informat...

Turns out the HNB replacement we got was bad. Got a new HNB board and was able to run a TECF and TECC without issue to get car back in service thanks ...

Good to know. Didn’t think about doing it directly from controller either way good couple things to try before I grab generic programing and go that r...

It’s only a 2 stop so just the 2 HNB and top works fine after clearing and running TECC even though TECF fails at hn1. The second call will come back ...

I’ll check that tomorrow. Just seems weird that it wouldn’t be as it was working fine before the building power issue so honestly that didn’t even cro...

It’s wired top down the top hall call will learn and start working after the TECF just the bottom landing that fails

I guess a little back story building had power issues we were blowing the pico fuse on the 1st floor HNB that was fixed with the new button board. Hal...

It was actually something on the function board that got it at least moving but then I never got HS. Traced that back to a bad ribbon cable wire comin...

Dirt-no adjuster prints I’m going back today with I/o boards as that’s what I’m leaning towards just hope I’m wrong.Elm-once high goes away it goes in...

No I just get inputs. Controller does absolutely nothing. No direction relay picks and no starter picks. Does the same thing in inspection. SAFR is pi...