Elevator Forum

Am using the controller from Berlin.You're right the error log is in Motion control board not really the drive.

Yes am out side of states

Yes am out side of states

HiAm having trouble completing learn run on MCS321M with ovf416 drive it's a Mod, it just abort and show" Learning aborted " and no error in drive

MCB board does give the reason for abort

It's a mcs321m it uses MCB board for learn run,It have PRS2 on top of the car DZI DZI DZ2 signals with magnets on the tape in shafts.When learn run ab...

I am having difficulties completing learn run , it learn up to 3rd floor and bombs out sometimes goes back again to ground floor on its on to restart ...

HiHaving trouble completing learn run keeps on bombing out on or just after 3rd floor sometimes goes back again to group floor to restart learn run ag...

HiI am having difficulties to complete learn run on MCS321M with ovf416 drive it's a mod.23 stops at 3.5m/soKeeps stopping sometimes just after or bef...

HiMy lift is showing error 55-94 it bombs out as soon as relay C1ST and C2ST attempt to pull in.it does not move at all.