Elevator Forum

check the 2a2b relay of HZ..this has to drop out when you stop the n/c contacts are on the ground side of xdo feed..

Thanks,powerspike took out the cpu,as well as the option12 in the RAM. for freight elevator control,driving the cd,rc outputs crazy. this was a good o...

problem being..this is a freight elevator with peelle doors..there are no direction arrows..unfortunately..this output is triggering the cd output wit...

..might want to changeout the motor had a problem recently on two of my cars at random jobs..

...thats a deal..i bought mine recently on ebay for 250.00..had it updated for half the cost eci wanted..

if you have more than one car in the same bank.you can upload the parameters from a working car from the clc ..and than download it back into the car ...

I have seen instances where the clc has to be cleared of all faults in order to accept door operator parameter changes..also have had better success p...

check you clc parameters car 1 is always the master ooo,car2 is the first slave 001,and if you have a third car in the bank it is designated as a 2nd ...

I am looking for prints for an early version Dover composite ..this has the Dover overlay for the fire service..i need to get this information in orde...

..sometimes all it takes is a little adjustment on any of the floor vanes which operate the sensors..followed bt a new learn run..goes a long way..

Check your C1 Capacitor on the controller,you want to read close to 29volts or better.this feeds the 24volt logic for the processor,an open or leaky c...

I have 9 of those on one job.i encountered defective sockets on the leveling board card where the sensors plug in this will give you problems ad well....

Those miproms tend to get a little funny ..I have had this problem and I had to reset it by ..intermittently making the input hi..I will get the info....