Elevator Forum

Vertical Express will sell a complete MOD package for this. Why are you wanting to MOD

I don't know about CA but in NY no new ship or sheave can be installed today. However if the car is original and controller original they can stay. Th...

It is not moving when its burning out the motor.

I even did one better by cutting all connections and re-stripping them and reinstalling. This was done in the main electrical room, disconnect switch ...

good luck with the packing job. Those suck. you might need to Buck boost transformer to help with the power issue.

fluid is newvalve and pump were changed Soft start is brand new as well.Not sure what an AVR is but I am going to google it and find out

phase monitor was installed motor 2 or 3 settings for low/high and std missing should trip it out. I don't even see the light flicker on the camera wh...

I feel the meg test should of picked up on any insolation breakdown of the wire within the pipe. Again this is why I am switching power feeds at the c...

I installed a phase monitor so if the voltage goes to low/high/missing it should trip. Do you know of any line monitor systems? Both elevators share b...

Yes. we changed the oil out on the (2nd) motor and (4th) motor. The oil was looking/smelling burnt.

submersible. We changed the pump out on motor 3 incase we had a bind.

This is only for new/mod elevators. I have confirmed that NYC DOB will be putting this into affect on 9/29//2018. Now I just need to know if this is f...

The bottom of the hall callboard should have a black plug in jack. This is for the key switch. However if your looking to add this you will need the m...