Elevator Forum

Check the micro switches in the operator (both N/o & N/C) CHECK THEM ALL. Make sure the cams are making up the micro switch if that doesn't work c...

I had this problem before. The selector tape guides we off center so when they got a little worn the elevator would loose the floor position. Loosen u...

6V battery runs the bell and the lighting unit. You could of looked up the bulb info and found the voltage. you should have 120vac feed(2 wires fed fr...

used the KISS method and went thru circuits one by one. I was able to fix.

Try hooking up directly to the controller... But chances are you lost the battery, so a set up will be needed. Last edited by KSNY; 02/19/16 12:37...

I have IMS and already had a buddy of mine for TKE come over to the job, with NO luck. It wasn't ordered with security floors for the car, it was adde...

To reload the job I use the floppy disk for the site, push the RST & UDL on the 188e board then loaded each file individually. I didn't know I had...

Only changes I am making is in the "Smart Fast" so like (s10,s11,s12...) and in the group (CS4,0CS4,1)....

A company made a laptop that would allow you to communicate with the interface of a tac20. One of its features is "input injection" this would allow f...