Elevator Forum

I would use GAL at that distance and speed. I've never done one that tall and fast, but I would trust them the most to help me through it. Sounds like...

If you need help developing a tool I know someone who could possibly help......but not sure if they would for legal reasons though

If you are still looking for this part I may be able to get you a working used one that was taken out of a building....

If it were a 2 stop you could do it very easily by adding a slowdown switch that will drop out your high speed cool......more than two stops and I agr...

Thanks guys looks like carpet is the way to go.

Worst pos is Garaventa Artira in my opinion. They suck.

You're crazy. Siemen's soft starters are great. Also how could you say I2, I3 and EECO valves are bad? Learn how to adjust them. They seem to hold the...

Figured it out. O43 parameter had to be changed

No, I live in Alabama. I will try to get you some technical info this week if I can find it. Best bet would be to find one of these units that is gong...

Once jumpers are on you must reset the door board for the change to take effect.

I may be wrong, but I think you change the hand of the door by putting jumpers on in the corner of the board by where the open and close buttons are.

I might be able to get you some technical info, but parts would be as scarce as hen's teeth.......what parts do you need?

Not really, the best bet is to get another one and try to seal it really good with vaulk