Elevator Forum

Email me at [email protected]

Where in the USA are you located?

You need to install a micro switch for the limits on the hangar track for each limit. you cant use the signal on the door board.

Does the car run to a random floor after making a run, or does it just sit at a floor and randomly go to a floor?? Do the lights for car and hall call...

Is an Impact controller a Dover/TKE controller?

I would wire a relay to pick when you put the phase two switch in the hold position. Then use the contacts to disconnect the door close signal.

In hold position

I don't have a print handy, could it be wired to an incorrect input?/ I tried the fire service on a two stop today and door close does not allow the d...

Assuming you have an ICON Controller, what is fire Service adjustment F16 set at?? If you are not in a state where there is some farout code deviation...

I don't think there is a check valve in the jack ass'y, just a seal at the top. The check valve would be in the pumping unit and valve body. What prob...

Sounds like it is not suiciding. Check contacts in suicide circuit. Check 14 & 15 contactors for loose armatures.

Sounds like the selector is working correctly. There is a relay tat picks to tell the elevator that a stop is necessary. Gotta find that relay. Look f...

Also, auto correct only corrects when the car reaches a terminal landing

Selector should auto correct. If it doesnt, just put it on insp and turn the screw until the movable nut is at the correct position. When you run the ...

Send me your email and I will send a couple of older Westinghouse prints for single speed and two-speed machines. That may give you some more informat...