Elevator Forum

Today I went to try run learn again and now I get no response from device when service tool is connected. . I isolated the clc board and still got no ...

I have never replaced DMC software. Only the clc board but used existing chips. Does world electronics sell software chips ?

I think once I saw error code saying it didn’t get slow down when run learn failed and RER showed on tool

It also will not let me set up valid floor openings which I have never seen before

Check you SCRs

I’m not poking around. I have been in the business for 30 years . The prints were taking off job. As well as testing procedures that include the gov t...

There’s no print. Just an owners manual that is garbage pretty much Last edited by Jluff; 08/23/19 01:30 PM.

What are the jumping points ?

Also need jumping points for OS and Governor for Gen 2.

You can buy the orange cable.