Elevator Forum

Does anyone have programming instructions ?

The board with the battery ? If I disconnect this board will my fast program connect ? Do I lose my programming when replacing this board ?

Clc is in the car station panel? Or in the machine room ? Which board in car station pAnel if that’s where it is ? Last edited by Jluff; 05/23/19 ...

Thanks dirt

Is The capacitor located on the PCB relay board in machine room? Does the whole board need to be replaced ? There is a 4-6 week lead time to order thi...

Happened again after 8 days working great. It was happening every 10 times or so the doors opened before replacing the door motor. Now I’m very confus...

Changed the door motor and it’s working good .. thanks guys.

I can not find wd1 and wd2 on the print How would you properly check the door motor ? Last edited by Jluff; 04/04/19 03:50 AM.

I am not losing WD. that is lit all the time. It’s WD 1 and WD 2

Changed the board. Still WD1 and WD2 flickering and door not closing.

It’s intermittent and happens on all floors. WD Light on door board flickers and drops out. Door stays open.