Elevator Forum

RCDWhat kind of work do you do?

Thanks Bill,This elevator was installed back in 1983. I'm sure it the original oil and likely the original packing. We have had this elevator for a sh...

DanCheck to make sure the relays drop properly for both the car and gate.

GeorgeUnitec is owned by Otis. Try them for what you are looking for. Good luck! The building owner would have a better chance of getting that info. S...

Thanks Philly,I gave them a mod contract to consider. New rails, sling, platform and cab. Even suggested a new controller & VVVF motor. I doubt th...

LocalELSCO doesn't have anything for that wide of a rail.AbeI'll ask Mike!EI was thinking of that. Maybe some kind of insert made out of brass.Thank y...

MikeMotion Control Engineering has prints for O'Thompson...

1220Does the door open and won't shut?Or won't open?Or like copper dog asked is it rolling back?

Tom,Try a heat gun or hair dryer!

Rollaway,Did you test it with a balanced load? Did you test it with the full capacity?Looking at you previous post. I see you looked at the encoders. ...

ESCO was from Fort Lee. I'm not sure if the were purchased or just closed their door. I do have prints for a unit of that vintage. But, I'm sure you a...

SThe 3 that comes up first is a map location in the CPU. Using your menu button you can view screen 3 velocity. It seems one or several NTS switches a...

Call Unitec (Otis Elevator)(800)328-7840[email protected]