Elevator Forum

ABE,Is there such a thing?We have Two stop where the MCE controls do not sync the jacks. We just sync them every time we are there.Syncing the jacks o...

I may have some on an one of my jobs. What is going on?

Thanks for closing out your post!

5v power supplySheild traveling cable not installed properly ResistorJumperAny of these things that relate to CAN...

Dean,If you can take a picture of the governor that would be great. Many of this style elevator use a governor that allows us to overspeed it at the g...

Although I appreciate your concern, learning to perform the test does not ensure an inspector will allow you to do so. I'm sure you are competent at w...

Good point Magic!Yeah like he said. Check and see if your unit has OLT and its enabled.Funny I missed that after spending several hours running a unit...

Personally, I like the way it is setup.

It just a suggestion, try making the lowest landing your home landing for a month. Then check your stall time value, it may be set too low.

Is the CLC communicating?Loop back?

Hang the car and counterweight. Take a dynamometer and weight the counterweight then the car. Take the ropes off and take amp readings in both directi...

Yeah, not much of a hat guy myself. Only when we hit really low temps. I like the BBQ usage! Too funny they all share they are using them so creativel...

Just an update, it's been three months and I think I have a keeper.Streamlight Stylist Pro,So far it's holding well and the charge last.

Chi,For 106, is SKD1 on? 106 could be a loss of a 3 phase (single phasing or low voltage). It may also be a loss of 115vac crip input for your safety ...

Turtle,3 years! The elevator service men must have been charging a fortune for having to clean up the extra dirt.I do have some questions.When were th...