Elevator Forum

Not sure what software, I haven’t payed attention but will look this week. I have also seen this safpld input flicker on and off.

I agree with indirt on getting ims. I downloaded it from liftware.ir. They will give you a temporary site key to try it out then you have to pay 1500 ...

Cemco residential. I just replaced one of these with a maxton emv10. It came with a conversion kit with good step by step instructions. Practically pl...

Order seal kits as well. That’s more than likely your problem.

It was 1COR. Bad iobd board not let any outputs out. Major heat damage to lower right side.

Maybe so. I haven’t been there yet but going first thing in the morning. Tech said it was down with doors open on 2nd floor. Won’t reset or run on ins...

So I tested ,like you described VTR tech, and had to replace all lcehas & lcefcb boards. It then took a lon download and allowed a hoistway scan. ...

It won’t let me scroll through floors at all but it shows what floor the cars at (1,2, or 3) after I cycle disconnect. Maybe it comes from factory wit...

Yes drive ok is on. It’s funny that there’s no shaft comm on but it won’t let me do a shaft learn but it will level into floor, I can cycle disconnect...

Doesn’t try at all and it won’t let me scroll at all to put in call from cpu. I’ve done 5 7 1 many times. Earthquake is off. And I’ve tried shaft lear...