Elevator Forum

Oops, I shouldn't have said "definitely"! Thanks for the update

My manual only goes to A148 also. Better call Smartrise in the morning. The debug menu should have some history and a description of all of the faults...

It's definitely the optical sensors. Ask a Schindler guy and they will tell you they are unreliable. I have had them go out on relatively new units, a...

I do mods, and a lot of conversions to elsco guides. I haven't found anyone who makes specific conversion plates for different manufacturers. Last job...

Where are you cutting and pasting this stuff from?

Consider switching to decaf coffee.

Great! Thanks for reporting back.

Hmmm, if I gather correctly from what you are saying, it will slow down, but not stop, and not open doors, and not cancel calls at intermediate floors...

This may or may not be what you're looking for. This is all I have for ESCO prints. Good luck. By the way, it is pure coincidence that our usernames a...

Relay logic with no prints... tough to troubleshoot over an Internet forum. I can't help you out about prints, but here is how I would approach it:Ans...

Have you verified that your drive parameters match your motor nameplate data? For hoist motor RPM use the FL RPM not the rated RPM (for example rated ...

Try increasing the speed pick delay parameter. Default is usually set to 0.500s, start with 0.750s and see if the rollback gets better.

Who specifically are you referring to when you say they are doing it wrong, and what specifically do you think is wrong with the procedure? Try to be ...

You will get the GS input failure if the controller sees the gate switch made up when you don't have a door lock or the DPM input. The controller thin...

One easy thing to look at would be lang lay ropes rather than regular lay ropes. Lang lay ropes will provide more traction, usually used in U-groove s...