Elevator Forum

Is it a stand-alone tool like the old Montgomery one or PC based?

I don’t think you can buy a tool that supports the Miprom SL. But let us know if you find out otherwise.

I have found on those type of ralays when used on DC door motors, the contacts will pit in the direction of current flow. A peak developes on one side...

Ya, I’d like to see it. I have something like that but it starts on page 7.

God I hate those! We were at a point once that we were willing to buy the Kone tool but the one they sell now doesn’t even work on an SL. I call them ...

Actually it does run fine with the additional landings board unplugged. It’s just a 3 stop.

I meant Endura MRL, not Endurance MLT. V6? I’m still on V5R0P. Is that on the Lobby?

I don’t think that’s related to it being an Endurance MTL. I’ve seen this fault several times with newer versions of software and we don’t have those ...

Yes I have seen the Otis bulletin on adding a timer to simulate up to speed. But for a Siemens starter it seems non-sensical.

Bring a logic board. Or if up to speed is stuck closed you can brake off the little surface mount cap that shorts around the SSR contact. It’s almost ...

If you look at the print, the up directional limit feeds UXA but level up comes in to pick U1, U2 even with UXA de-energized ( Page 3 of the print I’m...

Ya, that’s what I was thinking. Valid front openings for car set correctly but valid front openings for group wrong. 52 should = 56 and 53 should = 57...

Are CLC adjustments 52 through 59 set correctly?

The input is serial from the door board to the CPU so it’s not going to be the IOD. You can read the input at the door board. If it’s good there repla...