Elevator Forum

Notifications
Clear all

Otis 211

9 Posts
6 Users
0 Reactions
18.3 K Views
(@johnny)
Honorable Member
Joined: 17 years ago
Posts: 473
Topic starter   [#22938]
Does anyone have a list of faults for an Otis 211. I have to go to an out of town job on Monday and according to customer, display after reset shows MUSS I think this has to do with the starter or the motor up to speed contact on the motor starter. Any help would be appreciated.



   
Quote
(@rolly)
Honorable Member
Joined: 17 years ago
Posts: 729

   
ReplyQuote
(@notime)
Reputable Member
Joined: 17 years ago
Posts: 197

   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Bring a logic board. Or if up to speed is stuck closed you can brake off the little surface mount cap that shorts around the SSR contact. It’s almost always the problem, so much so that they don’t put it on the new boards.

Last edited by Indirtwetrust; 02/04/18 04:22 PM.


   
ReplyQuote
(@rustyiron)
Eminent Member
Joined: 17 years ago
Posts: 34
 
The MUSS fault is is a well documented symptom resulting from a failure in the soft starter. The Otis solution is to provide the signal through an added timer and the Run Input.



   
ReplyQuote
(@indirtwetrust)
Noble Member
Joined: 17 years ago
Posts: 1759
 
Yes I have seen the Otis bulletin on adding a timer to simulate up to speed. But for a Siemens starter it seems non-sensical.



   
ReplyQuote
(@rustyiron)
Eminent Member
Joined: 17 years ago
Posts: 34

   
ReplyQuote
(@johnny)
Honorable Member
Joined: 17 years ago
Posts: 473
Topic starter  
Put the timer on per otis direction. Well somewhat, anyway. Also replaced the logic card in the Siemens starter for good measure. All is well and elevator is happy once again. Close to 1,000,000 trips on the unit. Thanks to all, especially Rolly and Jon.



   
ReplyQuote
(@michaeld)
New Member
Joined: 17 years ago
Posts: 1

   
ReplyQuote
Share:
Scroll to Top