Elevator Forum

Do you have a print? DCC input comes from the N/C contact on the starting contactor. PMC for X-line, MC for Y/D.

I assume this is the old DMC-1 program that’s associated with IMS on an “eBay” laptop. There are a lot of things that can keep that program from conne...

On your regen card, make sure J1 & J2 jumpers are on for 60hp and R160 is in place for 460vac. This comes from a difference in the DCN parameter a...

Agreed, but would add that this can also be caused by the packings. Best results with black Gorman packings.

6300PY2 & 6300PY4 are for DMC6300PY1 & 6300PY3 are for Tac20You can have the same problem with FX boards but I’d have to look those up

You sure you weren’t taking resistance readings with power on? Only reason I can think that would cause changing resistance.

Well none of that sounds right. The resistance measurements are taken with power off. There’s no reason to even turn the power on until the loading re...

So first make sure 60 ohms from CCH to CCL with power off, that’s 120 ohms at the IOD (actually from CPUA jumpers) and 120 ohms at the CWIL (resistor ...

Make sure you copy the chips while you have them

I’ve see like setup required or door disconnect required.

Door and selector boards come with software, just 1 chip. I’ve never had reason to change software on either. How’s you end up getting the DK13?

What I have says you need at least a CV2 selector with 675AD9 software or newer. Door board has to be an FX or PY. The really old ones won’t work.

What was the original problem?

It should say something before TST Disabled