Elevator Forum

Actually I got the encoder speeds the same using the real time display encoder estimator. Adjusting 6-64 to that, adon learn,adjust, adon learn and so...

109 3065 1 0Mx10 machineAlso brake test 6-30 was set to zero yesterday. Today I saw it do one and fault, it's set to 1 now and I can only make it 1,2,...

Yes and yes

Thanks, so your problem was the AC end? Good one. Was it running the wrong RPM or bogging down with a load?

I checked out that thread by Solidstate. Does anyone know what the resolution was?

If Uniprom is the controller I'm thinking of, there should be pots for LHT, SHT, LCT, SCT. Long Hall Time, Short Hall Time, Long Car Time, Short Car T...

Does it do this at every floor? Either door or just one?

Yes it is, UP Slow

The 7 pin plug laying in the bottom of the controller is for a run bug

You should also check the DHT and DHR brushes in the selector and DX contacts

You should pick DC down call transfer, to pick CS car stopping relay, picks CR which drops the call and picks CST which picks SE to open the door (OD)...

There was a similar question about a month ago on a WCR Hydro. You might want to check it out but I'll check the print.

Sounds like a broken down muffler. I have seen it look like coffee grounds and also like little rubber granuals that clump. The mufflers Kone used in ...

It sounds like the encoder position does have to match the previous alignment values for the C1 error to clear. Interesting.