Elevator Forum

Go to that event 2703 then press blue key 3 Enter. See if it has subcode. Anyhow whats the event before 2703? Also monitor Inputs and Outputs Last ...

send me you email address

Is there a jumping points? none. Reset through a test tool? Did it trigger drive blockage?O wow, do pls. see the governor.

What type of controller do you have? 2703 code is like a 300vfe drive. Events on Gen2 is from 0 to 900 Last edited by gutmonarch; 10/02/19 04:39 PM...

what sort of error codes you got there? Have you tried clearing the errors and doing learn run?

Originally Posted by elevatorguycny Motor was wound wrong. On it's way back to us for the 2nd time. Oh crap. 😁Shite happens sometimes. Last edited...

This may help

Originally Posted by KSNY fluid is newvalve and pump were changed Soft start is brand new as well.Not sure what an AVR is but I am going to google it ...

If there are no laws there would be no any proprietary info. It does depend on country to country, i should say. Last edited by gutmonarch; 02/24/1...

Since the units are in the same bus, swells might be occurring internally or harmonics is a possibility. Root cause might be1) old hydraulic fluid (a ...

Originally Posted by gutmonarch Park the car where the car and counterweight crossheads are even, and use the "set EQ midpoint" function on CADI or SM...

Originally Posted by Engineer99 Good point E99.I think information is information. There is a lot of it thanks to internet. Responsible or not when gi...

Originally Posted by zammy Originally Posted by rac66 Zammy, you've got employees of "Cartels" that can't fully work on their own equipment because on...

some error needs a service tool reset. The cartel has its way of doing it.