Elevator Forum

Indirtwetrust, with the D3000 board, all that is utilized is the DC motor. All mechanical parts as well. The ones we modded were LD-03 with 120vdc mot...

Are you sure the motor is 20VDC? The 2 we did had 120vdc motors, and we used the D3000 board. Send me your email and I will send you the book for the ...

Smartrise has a door board that will work as long as the door motor is DC. The reason we went this route was due to having the single post above groun...

Id be looking at the motor contactor contacts. If it was a building power issue, you would most likely get an under voltage fault. Is it the original ...

Found what I needed.

Ill send you a PM Stall Protection with what they charged us.

The Galaxy Controllers I have like there 5vdc to be at least 5.2vdc. When it drops below 5 I start to have issues. Most of the time I just adjust it w...

It is crazy that Unitec is already stating these units are no longer supported. These are some of our "newest" elevators we service.

Last time I had an issue with a 211 board we sent to Unitec to be repaired. Cost wasn't too bad.

Looks to be a residential elevator?

I believe World can repair these or mayby ECI? Last edited by Goat; 02/03/22 08:31 PM.

Nevermind. Check valves showed up today... Vertical express apparently doesn't know the difference between a hole in the ground and well you know...

I personally would not mix the 2. Is this a new job? Submersible motor? Are you sure the AW46 non-conductive? I had a job at a refinery one time where...