Elevator Forum

PM me

Agreed they are a necessity to have if you are going to have these on your route. We had and issue with one that it would not give a correct fault dur...

So I did what you said and I all the way back to pin 11 and 15 and no continuity. 11 is going to one side of TSL and 15 is going to UTS but it look li...

You are correct by proper voltages there is none showing on TLS3 to AC2. The switch is good when i i check from TLS3 to UTS1 I get 106VDC then motor s...

The motor starts and it will just basically sit there and bypass until it goes on low oil. I checked the switches I am getting voltage proper voltage ...

I am in the same boat on a DMC as well I replaced the relay board and same thing. I am showing continuity on TSL3 and TSL4 I can see any breaks in the...

I tried what you said and it did not fix the issue. Anyone have any ideas?

I have run into the same problem except its the first and 3rd floor hall call. Are you talking about the capacitor near the reset button?

What vintage of controller do you have?

I will be honest I have no experience with the galaxy but I have installed both Pixel and Smartrise and they both have things I really like but I woul...

They are pretty good I think they have a great concept going. I am not a fan of Vertitron.