Notifications
Clear all
Topic starter
23/03/2017 5:09 am
I am working on a DMC and the top access switch had gone bad so I replaced it and it was working when I left. State came and inspected the elevator and wrote up top access not working. I went back to check and sure enough now I can only run it on hoistway access if the hall door is closed. I do not seem to have a full set of prints that show how Dover jumps out the top lock, does anyone know or have some ideas?
23/03/2017 9:02 am
It should be HA N/O contact 3/5 or, HAT N/O contact 6/4