Elevator Forum

HiPM me for parameters.

Hi Billvator,On the residual magnetism, check the gap between the armature and the flat washer where the screw that holds the coil in. if there is no ...

Hi JopOSopHop,I have a PDF file of Garaventa express II lift , email me [email protected]

Try the oldest trick in the book, take the logic board out of the running elevator and put the bad logic board in running elevator. Sounds like you e2...

Being a adjuster trained by Otis for over 20 years. Jumpers were mandatory for mods , new construction etc.Otis uses bright green or bright Orange Jum...

This is classic problem, Robicon drives from the 1980 -1990's would burn up the transformers the same way. The generator testing the load induces volt...

Yes...The old flip-flop switches were a primitive door zone...if the car hit the switch it would drop the relays and slide on the brake... If you tigh...

I have old prints for this 1-SOB I bought all the old parts/ prints from a old Otis Office. If you need them...

Hi The imotion operator has two types of boards imotion 2 (ABA26800AED1)30DC Input to DOBD @ P6-230DC Input to IOBD @ P12-2120vdc input @ PSSB P8-1 TO...