Elevator Forum

Yes, very similar operations. The older codes allowed "bypass" on the keyswitch, where with the smoke detector still active/building on fire you turne...

I bet you its one of the two third floor limit switches mounted to the duct. I'd Park it near them switches, LOTO it, and clean the contacts with emer...

I've used a screw and vise grips before one on the was real stuck. But 99% of the time a good set of picks does the job. If I remember correctly I got...

Remove wire from INB/IN to put it on inspection. Jump p24 to INU or IND to run up or down. Jump AC1 to TDL to bypass top normal limit and put it on th...

Thank you for taking the time to post what it was. So nice to get to hear what it was.

I haven't done it yet. Smartrise supposedly has a full mod package for Ecospaces, with a five year warranty on everything electrical. They keep the Ko...

The codes your missing aint in the normal fault code book. Theres a seperate little book of codes just for the drive. I have it, post back with the su...

Go to menu E. Sub menu 1 and hit enter. It then lists fault codes. Up and down to go through them. F1 is newest. On a fault code that has a subcode hi...

Access electronics in Waldorf Maryland. They repair lots of boards and drives.

BRG, did you have many issues with the pick switch with only .002" of lift? The last brake I replaced on a Kone was on a MX 10 machine. I'd set the ga...

The brakes not holding is one thing, the car not being able to run up with a full load makes me wonder about the counterweights. Whats it counterweigh...

I also have had a good number of FCU edges just go bad. Usually the same symptoms jblack described. But for the most part they do last a number of yea...

If its anything like the brakes on the smaller ecospace machines (mx10) they are not adjustable for holding force. In other words, if it won't hold th...

I second virginia controls. I've installed 100+ hydros with a VA controls MH-3000 controller. It uses a microprocessor as the brain, a large relay boa...

I've never used the Adam's soft stop additive. Maxton makes Maxglide, especially for stickslip and hard take off conditions. The few cars I've used it...