Elevator Forum

I just spray the screen with brakeclean to clean it out and put it back, preferably with new o rings.

If it is grease could explain it, grease will get sticky after awhile. Most ecospaces I have have little plastic auto oilers on top of the guide shoe ...

Very interesting what worked on your car! Completely the opposite of mine. Which Torin machine is your car? The one I just couldn't get to do a roped ...

Thats very similar to what mine was doing as far as running 2 seconds then stopping with a rotor align fault, which the only thing causing it to fail ...

Just went through this on the same equipment. Are your ropes on? My construction guy did the encoder alignment wrong but was close enough to run. Car ...

Sounds like it needs bled. It's a PITA but it has to be bled well to get all the air out of all the stages. Or it will be bouncy.Also if the internal ...

You can leave it in, when they quit working usually the button just doesn't work but all other floors do. You could move that bad board to a top or le...

Sounds like a bad cpu card. I'm sure Dirt will correct me if I'm wrong here, but a tac20 doesn't have volatile memory. If your 3v battery was dead it ...

Is your pre torque setup? Could be an issue with pretorque not working causing movement before the brakes fully lifted. Could also look into things re...

Was the low timer a float switch on the old tank unit?Code allows for a timer or switch for low oil protection

I would Start by disconnecting the car button board from the ciohna board and if that doesn't stop it, disconnecting the hall boards from the criphna ...

Does anyone happen to have any schindler papers on this phone, celluar phone box? Programming manual etc?

Your right. Any car like that I do tests on I usually write on back of the controller door the switch and the terminal numbers to jump to make life ea...

Aw come on. These things are ridiculous, I'm adjusting one out right now..Smartrise is really really not impressing me at all. They completely forgot ...

Maybe someone does have some papers, but generally old stuff the mechanic just looks at the prints and figures out what to jump for what he's doing. R...